Oklahoma Hunting Forum banner
1 - 1 of 1 Posts

·
Administrator
Joined
·
16,037 Posts
Discussion Starter · #1 ·
Took the new 10mm to the range today with the 180 grain blue bullets I loaded up the other day.
Got set up in front of the plate rack, fired all my reloads plus 50 more factory loads with zero issues.
This pistol has replaceable back strap grips to accommodate different sized hands. Need to verify the small set has been installed.
The newly designed trigger has a lot of take up and my hands are not the biggest, so could only get the tip of the finger on the trigger.
If the grips are indeed the small set, I’ll swap out the trigger for an aftermarket Apex that sets the trigger back to a more comfortable and correct position for me.
Don’t get me wrong, the factory trigger is actually pretty good for the masses, just not for me.
Had to do the same replacement with the S&W Series 1, 5”pro I used in USPSA matches.
Put a Riton red dot on the pistol, sold on Ammoland.com.
It had all the features like shake awake and 50,000 hours of battery life. The pistol was designed to run a dot that could cowitness with the dot. Did some dry fire practice before heading to the range.

Automotive lighting Automotive tire Plant Motor vehicle Automotive mirror

After the first shot, the dot went left about the width of the front sight and stayed there the rest of the shooting session. I’ll bring it back to zero and run some more rounds through it to see if it holds zero.
If not, a Holesun will be on order shortly.
 
1 - 1 of 1 Posts
Top